FLANGE MOUNTED CLUTCH BRAKEModel 162521070-D-0707
21070-D-070710FMCB 1625NOTE: Refer to Figure 10.1. Remove the four Socket Head Cap Screws (Item 8) and slide the Female Pilot (Item 1), Bearing (Item
1121070-D-0707FMCB 16251. Remove the four Socket Head Cap Screws (Item 15) that secure the Air Chamber (Item 14) to the Housing (Item 7) (See Figure
21070-D-070712REPLACEMENT PROCEDURE–MALE PILOT BEARINGSFIGURE 13WARNING Always wear safety goggles when working with spring or tension loaded fastene
1321070-D-0707FIGURE 14This Ball Bearing disassembles along with the Stub Shaft and installed in Install this Retaining Ringfirst. Then press the Ball
21070-D-070714REPLACEMENT PARTS LIST ITEM DESCRIPTION QTY 1 Female Pilot 1 21 Bearing 2 3 Retaining Ring (Int.) 2 4 Drive Disc 1 6 Re
1521070-D-0707REPLACEMENT PARTS LIST (continued...)FIGURE 161919302030375858375 ITEM DESCRIPTION QTY 5 Shaft 1 19 Key 2 20 Bearing Flange
21070-D-070716WARRANTYWarrantiesNexen warrants that the Products will be free from any defects in material or workmanship for a period of 12 months fr
In accordance with Nexen’s established policy of constant product improvement, the specifications contained in this manual are subject to change withou
Table of ContentsInstallation ---------------------------------------------------------------------------------------------------------------------
21070-D-07074NOTE: Refer to Figure 1.1. Insert the customer supplied key into the motor shaft keyway.2. Remove the four Socket Head Cap Screws, (Ite
521070-D-0707INSTALLATION (continued...)NOTE: Refer to Figures 1 and 3.NOTE: Use Loctite® 242 on all Socket Head Cap Screws.1. Remove the four Sock
21070-D-07076NOTE: Refer to Figure 41. If the brake is to be set when the solenoid is de-ener-gized, connect the port marked 2 to the brake and the p
721070-D-0707Pneumatically actuated devices require clean, pressure regulated, and lubricated air for maximum performance and long life. The most eff
21070-D-07078TROUBLESHOOTINGFEMALE PILOTSET SCREWHOUSINGSPLINNED DISCAIR CHAMBERO-RING SEALSMALE PILOTSPRING PINBALL BEARINGKEYSTUB SHAFTPISTONAIR TO
921070-D-0707REPLACEMENT PROCEDURE–FRICTION FACINGS 1. Remove the four Socket Head Cap Screws (Item 15) and separate the two halves of the FMCB (See
Comments to this Manuals