WEB CONTROL PRODUCTSUser ManualPaper CheckerPC210FORM L-20341-E-0208
10FORM NO. L-20341-E-0208Single sheet in Sensor gapSet the Web Thickness Selector Switch to the RIGHT side 0.008 In. - 0.031 in. [0.20-0.80 mm]Abnorm
11FORM NO. L-20341-E-0208FIGURE 60.80 Inch[20 mm]or more0.80 Inch[20 mm]or more0.80 Inch[20 mm]or moreDouble-sidedadhesive tapeAdhesive tapeWeb(A) OV
12FORM NO. L-20341-E-0208Single thickness of Web in SensorNormalNoneAbnormalIf the Web thickness is less than 0.002 In. [0.05 mm] thick, the Web
13FORM NO. L-20341-E-0208TesT Run in Web bReak opeRaTion1. Set the Mode Selector Switch to Mode 2 or 5.2. Set the Web Thickness Selector Switch as a
14FORM NO. L-20341-E-0208DETECTING SIGNAL LEVELThis control is factory set for normal operation and in most applications does not require field adjustm
15FORM NO. L-20341-E-0208SPECIFICATIONSylppuSrewoPzH06ro05,CAV042ot001noitpmusnoCrewoPAV01erutarepmeTtneibmA]C°05-°0[F°021-°23tupnIROSNESLANGISSUONORH
16FORM NO. L-20341-E-0208WARRANTYWarrantiesNexen warrants that the Products will be free from any defects in material or workmanship for a period of 1
In accordance with Nexen’s established policy of constant product improvement, the specifications contained in this manual are subject to change withou
3FORM NO. L-20341-E-0208Table of ContentsTHEORY OF OPERATION -----------------------------------------------------------------------------------------
4FORM NO. L-20341-E-0208THEORY OF OPERATIONfront panel and contact closures. There are two sets of contacts, one for overfeed or splice and one for b
5FORM NO. L-20341-E-0208FIGURE 2NOTE: Sensor placement is dependent on the application, whether web or sheet-fed type machines.SENSORSThe PC210 utili
6FORM NO. L-20341-E-0208ALIGNMENT (SEE FIGURE 2)1. The Transmitter must be the upper unit with the Receiver mounted below when used with a horizontal
7FORM NO. L-20341-E-0208FRONT PANEL CONTROLS AND INDICATORSThe Power Switch has an imbedded indicator LED that glows when power is on (See Figure 4)
8FORM NO. L-20341-E-0208Setup controls are located inside the cover on the front panel of the PC210. These controls are used to customize the control
9FORM NO. L-20341-E-0208OPERATIONDetailed operation, setup, testing, and troubleshooting for each mode will be described in this section. Modes 3, 6,
Comments to this Manuals