Nexen DPC-11T 961200 User Manual

iFORM NO. L-20070-F-1209AIR CHAMP® PRODUCTSUser ManualModels DPC-9T and DPC-11TFORM NO. L-20070-F-1209

7FORM NO. L-20070-F-1209OPERATIONWARNINGNever exceed maximum operating speeds listed for your product (See Table 5).WARNINGEnsure proper guarding of t

8FORM NO. L-20070-F-1209CAUTION PARTS REPLACEMENTFRICTION FACING (ITEM 4)NOTEInspect Friction Facings for wear, and replace when they are appropriatel

9FORM NO. L-20070-F-1209PARTS REPLACEMENT (continued)O-RINGS (ITEMS 8 & 9)NOTEReplace O-rings (Items 8 & 9) if there are noticeable ai

10FORM NO. L-20070-F-1209BEARING PARTS REPLACEMENT (continued)REFER TO FIGURE 9.6. Remove Retaining Ring (Item 17).7. Fully supporting the Housing (

11FORM NO. L-20070-F-1209REPLACEMENT PARTS LISTThe item or balloon number for all Nexen products is used for part identification on all product p

12FORM NO. L-20070-F-1209WarrantiesNexen warrants that the Products will (a) be free from any defects in material or workmanship for a period of 12 mo

iiFORM NO. L-20070-F-1209Copyright 2009 Nexen Group, Inc.Nexen Group, Inc.560 Oak Grove ParkwayVadnais Heights, Minnesota 55127ISO 9001 CertifiedThis d

iiiFORM NO. L-20070-F-1209Table of ContentsGeneral Specifications -------------------------------------------------------------------------------------

1FORM NO. L-20070-F-1209GENERAL SPECIFICATIONSSpecificationsTorque Up to 1243 Nm (11000 in-lbs)Actuation Pressure 1 - 5.5 bar (14.5 - 80 psi)Service Te

2FORM NO. L-20070-F-1209INTRODUCTIONINSTALLATIONNexen’s DPC (Dual Friction Plate) Clutches are designed to mount on shaft ends, or through shafts usin

3FORM NO. L-20070-F-1209PILOT MOUNT CLUTCHREFER TO FIGURE 2.1. Install Support Bushing if required.2. Thoroughly inspect tapered bore of the Splined

4FORM NO. L-20070-F-1209INSTALLATION (continued)SHEAVE MOUNTNOTEThe Sheave Clutch is a combination of the Pilot Clutch and Sheave Assembly (both shipp

5FORM NO. L-20070-F-1209SHAFT END MOUNTINGREFER TO FIGURE 4.1. Install two Elbow Fittings (Item 20) into the Rotary Air Union Cap (Item 25).2. Insta

6FORM NO. L-20070-F-1209THROUGH SHAFT MOUNTINGREFER TO FIGURE 5.1. Drill a 3/8" diameter hole into the center of the shaft; deep enough to reach