1FORM NO. L-20087-P-1112Straight Bore BrakeModels S-450, S-600, S800, S-1000, S-1200, S-1400, S-450A, S-600A, S-800A, and S-1000A
FORM NO. L-20087-P-111210NOTE: Refer to Figure 6.1. Remove the Retaining Ring (Item 9).2. Press the Friction Disc Hub (Item 1) out of the Ball Beari
11FORM NO. L-20087-P-1112 ITEM DESCRIPTION QTY 9 Retaining Ring 1 10 Retaining Ring 1 111 O-ring Seal 1 121 O-ring Seal 1 133 Dowel
FORM NO. L-20087-P-111212TABLE 6PRODUCT NUMBERS ACCESSORIESFIGURE 8BRAKE GUARDFIGURE 9TORQUE PIN BRACKETModel Torque Pin Bracket Brake GuardS-450819
13FORM NO. L-20087-P-1112FACING AND REPAIR KITSTABLE 7PRODUCT NUMBERSNOTE: Before ordering new friction facings, determine if your brake uses low coef
FORM NO. L-20087-P-111214Nexen Group, Inc.560 Oak Grove ParkwayVadnais Heights, MN 55127800.843.7445Fax: 651.286.1099www.nexengroup.comISO 9001 Certi
FORM NO. L-20087-P-11122Copyright 2012 Nexen Group, Inc.Nexen Group, Inc.560 Oak Grove ParkwayVadnais Heights, Minnesota 55127ISO 9001 CertifiedThis do
3FORM NO. L-20087-P-1112Table of ContentsGeneral Specifications --------------------------------------------------------------------------------------
FORM NO. L-20087-P-11124CAUTIONGENERAL SPECIFICATIONSSpecificationsTorque Up to 1130 Nm (10000 in-lbs)Actuation Pressure 1 - 5.5 bar (14.5 - 80 psi)Ser
5FORM NO. L-20087-P-1112INSTALLATION1. Insert the Key (Item 16) into the shaft keyway.2. Slide the brake over the Key and on the shaft.3. Install a
FORM NO. L-20087-P-11126AIR CONNECTIONSThe following is a common air supplied scheme used with this product. This is an example and not an all-inclus
7FORM NO. L-20087-P-1112AUXILIARY COOLING AIR CONNECTIONSNOTE: The auxiliary cooling option is not a standard feature. It is a passage through which c
FORM NO. L-20087-P-11128SYMPTOM PROBABLE CAUSE SOLUTIONFailure to engageAir not being exhausted due to a controlvalve malfunctionReplace the control v
9FORM NO. L-20087-P-1112PARTS REPLACEMENTFRICTION FACINGSNOTE: Refer to Figure 5.1. Align the holes in the Friction Disc Hub (Item 1) with the Machin
Comments to this Manuals